Can the cooling tower packing be cleaned and used again?

　　The cooling tower packing is made of polypropylene or polyvinyl chloride, which is similar to FRP, and will not be corroded unless it is damaged by man. Most fillers can be used after chemical cleaning. So what are the main points of cleaning and reusing cooling tower filler? Learn more below!QT5Cooling tower noise reduction treatment manufacturer

　　When the filler of the hyperbolic cooling tower is attached or blocked by dirt, which seriously affects the cooling effect, it is generally replaced with a new filler. In my opinion, it is neither economical nor necessary for the company to replace new fillers. What is the impact of cooling tower packing on water temperature? What are the key points for cleaning and reusing cooling tower packing? A single tower packing is about 130b2503, which is equivalent to 30 tons. Calculated at 10,000 yuan/t, a single packing is more than 300,000 yuan. In addition to the other parts and labor costs of the FRP cooling tower, all equipment must be replaced with hyperbolic cooling tower parts at least 400,000 yuan. Secondly, generally speaking, the bottom filler fouling is serious, while the top filler fouling is not serious.QT5Cooling tower noise reduction treatment manufacturer

　　The filling material of the cooling tower is polypropylene or polyethylene, which is similar to the anti-corrosion properties of FRP. Unless damaged by human factors, it is not easy to be corroded, and most of them can be used after the chemical water treatment is completely resolved. Therefore, replacing all new fillers is not an objective choice. After exploration of practical activities, the offline physical and chemical cleaning process is adopted to clean a part of the old filler first, and then remove a small part of the new filler for replacement. Compared with all alternative fillers, the fixed cost saves about 60%. Judging from the actual effect of refrigeration, this approach is the same as choosing all alternative fillers. The damaged filler has been resolved, and the manufacturer can also reuse it. The above is about "What are the main points of cleaning and reusing cooling tower packing?" I hope this article can be helpful to everyone. If you want to know more about it, you can continue to pay attention to Guangdong Teling Air Conditioning, a manufacturer of enclosed cooling towers.QT5Cooling tower noise reduction treatment manufacturer

Article Address：https://www.trlen.com/news/556.html